
Composite privacy screens
Sometimes the problem is not the whole boundary but one view: a neighbour's terrace, a window, a path above the garden. A composite privacy screen closes that view with a solid, warm-looking run of boards.
A composite privacy screen is a closed run of wood-plastic composite boards between posts or pillars, built at a specific point of a garden or boundary to block a view, rather than to enclose the whole plot.
What is a composite privacy screen?
In short: a section of closed composite fence placed where a view needs blocking, built on posts or pillars like a full fence.
A privacy screen uses the same boards and structure as a composite fence, but the design starts from a question: what do you want to stop seeing, and from where? The answer decides the position, the height and the length.
Typical cases on the coast:
- a new house next door whose terrace looks straight into your garden
- a seating or barbecue area visible from a footpath or street
- a ground-floor townhouse garden overlooked by upper floors
- the side of a pool area that faces a road (as a screen; pool safety barriers are a different matter and not a service we offer)
Screens can stand on the boundary or inside the garden, close to where you sit.

Where should a privacy screen go?
In short: often closer to where you sit than to the boundary – a screen near the terrace blocks more of the view with less height.
This is the most useful advice we give on privacy: a screen close to the person who wants privacy blocks a wider angle than the same screen far away on the boundary. A short, moderate-height screen beside the terrace can achieve what a much taller fence at the back of the plot cannot – and it may avoid height limits that apply on the boundary.
We look at the sight lines with you on site or from photos taken from the places you actually sit. Owners abroad can send photos from the terrace and from the window that overlooks it; that is often enough to propose a position.
For whole-boundary privacy, see composite on a low wall or composite with posts.
How is a screen built to stand up to wind?
In short: like any closed fence – strong posts in proper footings or solid fixings to masonry, because a screen catches all the wind.
A free-standing screen is often more exposed than a boundary fence: it may stand alone on a terrace or in the open garden, with nothing alongside to share the load. The posts and footings therefore matter more, not less.
On soil we set posts in concrete footings sized for the system and the ground. On an existing terrace or slab we may use base plates bolted down, only after checking that the slab can take them. We do not rely on planters, weights or fixings into tiles to hold up a screen.
Our article on what can go wrong while building a composite fence explains why this matters.
What about neighbours and community rules?
In short: talk to the neighbour, check the urbanisation's rules and ask the ayuntamiento before building a screen on or near the boundary.
Privacy screens are a classic source of neighbour disputes, especially when they block light or a view the other side enjoyed. A conversation before work starts helps.
Check also:
- the town's rules on fences and their height on the boundary, through the *ayuntamiento*
- your community's statutes, which may control anything visible from outside or from common areas
- whether a screen on a terrace in a building counts as altering the façade, which communities often control
The main site's guides on boundaries and party walls and urbanisation rules go further.

How do screens cope with sun and heat?
In short: like any composite fence – some lightening over time and expansion in heat – so colour choice and gaps matter.
A screen beside a terrace is often in full sun all afternoon. Darker boards absorb more heat and feel hot to the touch; lighter or mid tones stay cooler. All composite expands with heat, so the boards need the movement gaps the manufacturer specifies.
Read our guide on composite in strong sun before choosing a colour, and cleaning and stains for upkeep near barbecues and plants.
What affects the cost of a screen?
In short: length and height, how the posts are fixed, the surface you build on and access – listed item by item.
Screens are usually short runs, so fixed items such as setting out and access weigh more in proportion. Fixing to an existing slab, building on soil or adding a small wall at the base change the job. The factors are listed below; for general quote guidance see presupuestovalla.eu.
How we build it – step by step
- Sight-line check
We look at the view to block from where you sit, on site or from your photos, and propose a position and height.
- Setting out
We mark the screen position and the post locations and confirm them with you.
- Base preparation
We dig footings in soil or check and prepare an existing slab for base plates.
- Posts
We set the posts plumb and aligned, in concrete or on bolted plates as agreed.
- Boards
We fit the composite boards with the movement gaps the system requires.
- Caps and trims
We fit top caps and end trims so that cut ends and channels are covered.
- Cleaning and handover
We clean the area and hand over, with photos for owners not on site.
When is it the right choice – and when not?
A good fit if…
- Overlooked terraces and seating areas
- New neighbouring houses with views into the garden
- Screening a barbecue or relaxation area
- Owners who want privacy without fencing the whole plot
Consider another option if…
- Pool safety barriers – a different product and not a service we offer
- Screens fixed only to tiles or planters
- Places where community rules forbid visible changes
- Spots where blocking light would cause a dispute without prior agreement
What affects the cost?
We don't publish fixed prices: every fence is quoted line by line using these factors.
- Length and height of the screen
- Fixing method: footings in soil or plates on a slab
- Condition of the existing surface
- Composite board system and colour
- Number of posts and corners
- Access to the garden or terrace
- Removal of existing screening
- Licence or declaración responsable, if required
Articles and guides

Composite fence on a low wall
The classic Costa del Sol villa front: a low wall with pillars, and composite boards filling the bays between them. We build the wall, the pillars and the boards as one job.
View details →Composite fence with posts
A lighter way to build a composite screen: posts set in concrete footings with boards slotted or fixed between them. Ideal for rear gardens and side boundaries where a full wall is more than you need.
View details →
Composite fencing in strong sun
Sun is the main stress on any fence along the Costa del Sol. For composite it means colour change, surface heat and movement. Knowing what to expect makes it easier to choose the right board and colour.
View details →
Composite fences for families with dogs and children
A family garden asks more of a fence: it has to keep a dog in, stand up to children, stay comfortable to touch and still give privacy. Here is how composite measures up – and where it needs help.
View details →Frequently asked questions
Can a privacy screen go on my terrace?
Often yes, fixed to a sound slab with base plates. In apartment buildings, check community rules first, because visible changes may need approval.
How tall should a privacy screen be?
It depends on where you sit and where the view comes from. A screen close to the seating area can be lower than one on the boundary and still block the view.
Do you install brushwood or reed screening?
No, we do not offer brushwood (brezo) or reed (cañizo) screening. We build composite and timber screens and fences.
Will the screen block my neighbour's light?
It can, depending on height and orientation. Discussing it with the neighbour before work starts avoids most disputes.
Do I need permission for a screen?
It depends on the town, the position and the height. Ask the ayuntamiento and check your community rules (check case by case).
Can you build a screen around my pool?
We can build a composite privacy screen near a pool area, but not a pool safety barrier, which is a different product with its own requirements.
Can the screen be partly open?
Yes, some systems allow gaps between boards or a slatted top. More openness lets air through but gives less privacy.
What colour works best in full sun?
Lighter and mid tones stay cooler than very dark boards. Check the manufacturer's information on fading and heat for the boards you are considering.
Can you combine a screen with an existing fence?
Often, if the existing fence or wall is sound. We check how the new screen will be supported before proposing it.
How do I start?
Send photos taken from where you sit and from the view you want to block, plus the approximate length. We will suggest a position and send an itemised quote.
Planning a composite or timber fence?
Send photos and the approximate length by WhatsApp or the form. We reply with what to check and an itemised quote, no commitment.